Lift Support 1x Rear Liftgate Lift Support Strut Shock For 2007-2012 W164 LH

Product Overview

Item Description:Vehicle Location: LiftgatePatented Multi-Lobe Seal makes gas spring more tolerant to vibration and temperature extremesTwin Tube internal construction-Premium gas -charged cylindersDirect fit,Ensures easy installation and precise operationIndividually tested for performance and reliabilityBrand new and warranty offered!!!

This Listing is for 1 Support which fit the Following Applications:MERCEDESBENZ W164 2007-2012 LHHow to Properly Install a standard Lift support？ 1. Use Safety stands whenever a procedure requires you under the vehicle or supports. Or have someone hold the lid open for you so that they can raise or lower it as needed.

Slowly turn the screw driver and it will lift up on the band approx. 1/8",then pull the support away from the vehicle and it will release. 4. To install the new supports do the same procedure in reverse. DO NOT jam the new support end over the ball socket without lifting the U band slightly or damage may occur. 5.

Lift Supports need to be installed fully extended. In most cases you just can't compress them unless they are on the vehicle. If you have any issues during the installation PLEASE contact us. Never force a support. 6. If the ends are not lining up the support may need to be turned.

To do this attach the shaft end of the support to the vehicle and then turn the entire body of the support clockwise unit the ends line up. Important Notes about Lift Supports:1.

Each support is tested to perform as well as the original units and in many cases to exceed the manufactures specification,please ensure you replace all the supports in the compartment at the same time to ensure proper performance. 2.

Lift supports loose pressure over time,even sitting on shelves in most auto parts stores and many of the inventory liquidators on . Our business is lift supports,and we make sure to sell newly produced units,keeping our inventory fresh and rotated

• Before removing the old lift support,inspect the end connections and compare them to the units on your vehicle to make sure that they are the same As well as the extended length. 3. Remove the old support from the vehicle by placing a small flat headed screw driver under the U shaped band on the ends of the support.